Difference between revisions of "Installation"
From OpenPLi Wiki
| Line 18: | Line 18: | ||
'''AutoBackup''' | '''AutoBackup''' | ||
| − | When you have made a backup with the plugin [[Backup/AutoBackup|AutoBackup]] and this backup is on a media that is accessible from startup, it will restore all | + | When you have made a backup with the plugin [[Backup/AutoBackup|AutoBackup]] and this backup is on a media that is accessible from startup, it will restore all your settings, picons and some plugins from the OpenPLi feed. Depending on your internet speed and the data that has to be restored, this can take a few minutes. |
Revision as of 15:35, 2 May 2017
Notice: The instruction how to flash a receiver can be found at the Receivers section.
The installation Wizard
After a fresh flash OpenPLi will start with the installation wizard, which will guide you through the installation and the following steps:
- Select your language
- Video input selection
- Video Mode selection
- Overscan wizard
- Connect your receiver to the internet (when a DHCP server is present this will be easiest)
- Internet Connection will be checked
- Tuners will be setup, so you'll have to know which satellites you can connect to.
Remember there is no channel list installed, so you can do a scan or download one. Of course you can change all the above settings afterwards, if you want.
AutoBackup
When you have made a backup with the plugin AutoBackup and this backup is on a media that is accessible from startup, it will restore all your settings, picons and some plugins from the OpenPLi feed. Depending on your internet speed and the data that has to be restored, this can take a few minutes.
