Backup/AutoBackup

From OpenPLi Wiki
Revision as of 10:09, 21 May 2017 by 40H3X (talk | contribs)
Jump to: navigation, search

When you want to quickly flash your receiver and keep your settings, the AutoBackup plugin is a handy tool that will help you restore the necessary settings after a flash procedure. Settings that are being kept are: All your satellite and bouquet settings, CCcam / Oscam settings, network settings, timer settings, etc. etc. In fact almost all settings.

No plugins are being restored.

Beware: This tool can only be used when there is no major upgrade been done in Enigma.. Eg. OpenPLi 4 backup and restore with OpenPLi 5.



Backup-Autobackup-001.jpg

Make an Autobackup


Install the Autobackup plugin

Select a Backup location. Preferable a USB device
Daily automate backup: Enable
Select a time: e.g. 04:00
Create Autoinstall: off
EPG cache backup: off

To test, select the yellow button. If everything is ok, you see the Last Backup date with a recent timestamp.



Use an Autobackup


When you want to flash your receiver with a new software, take the following steps: Remove all the USB devices. Make a new USB disk with the image you want to flash your receiver. During the flash procedure.. Add the removed USB disk. Do this before the flash has been completed. (*1)

Depending the receiver the box will start immediately after flashing. During the first installation when a backup file is found on the USB stick a question is asked whether you wish to restore the previous backup. The default choice is 'yes'. Now the installation process will restore the receiver with the settings that are known before you flashed your receiver. In case you chose 'no' the box is flashed without restoring a previous backup, so you have to setup the box by yourself. In some cases it is better to perform a clean flash to avoid that previous experienced issues are restored.

(*1) Remark.. You can also put the image on the existing USB disk.. but you need to remove the image file after your flash procedure.. If you don't do this, your receiver will be reflashed if you update your receiver via the software-update option.