Difference between revisions of "Installation"

From OpenPLi Wiki
Jump to: navigation, search
Line 13: Line 13:
 
# Tuners will be setup, so you'll have to know which satellites you can connect to.
 
# Tuners will be setup, so you'll have to know which satellites you can connect to.
  
Remember there is no channel list installed, so you can do a scan or download one. Of course you can change all the above settings afterwards, if you want.
+
Remember there is no channel list installed, so you can do a scan or download one. Of course you can change all the above settings afterwards, if you want and if you want to invoke the wizard again you could edit the file "''etc/enigma2/settings''" and set the line "''config.misc.firstrun=false''" to  "''config.misc.firstrun=true''""

Revision as of 09:39, 1 May 2017

Notice: The instruction how to flash a receiver can be found at the Receivers section.

The installation Wizard

After a fresh flash OpenPLi will start with the installation wizard, which will guide you through the installation and the following steps:

  1. Select your language
  2. Video input selection
  3. Video Mode selection
  4. Overscan wizard
  5. Connect your receiver to the internet (when a DHCP server is present this will be easiest)
  6. Internet Connection will be checked
  7. Tuners will be setup, so you'll have to know which satellites you can connect to.

Remember there is no channel list installed, so you can do a scan or download one. Of course you can change all the above settings afterwards, if you want and if you want to invoke the wizard again you could edit the file "etc/enigma2/settings" and set the line "config.misc.firstrun=false" to "config.misc.firstrun=true""