Installation

From OpenPLi Wiki
Revision as of 18:52, 13 February 2018 by 40H3X (talk | contribs)
Jump to: navigation, search

Flashing = Installing OpenPLi


When you want to install an image like OpenPLi on your receiver/box/STB, you can do this by using an USB stick with a image (=installation files), which you downloaded from the download section. This procedure or method is called flashing. The instruction how to flash a certain type of receiver can be found at the Supported Receivers section of the Wiki.


Flash from the Menu


As of OpenPLi 6.1 there is the possibility using the menu (GUI) to flash your receiver to another version, (see animation below). Remember this is a flash, not an upgrade, so you will need an recent AutoBackup, if you want to restore all you settings after the flash.

Consider that for now, this is still experimental, see the Releasenotes of version 6.1. So be careful and first Backup everything.

Flash Procedure-001.gif



Installation Wizard


frameles

After a fresh flash OpenPLi will start with the installation wizard, which will guide you through the installation and the following steps (btw you can always go back a step using the "exit" button on your remote control!):

  1. Select your language (after having chosen the language, Enigma restarts)
  2. Video input selection
  3. Video Mode selection
  4. Overscan wizard
  5. Connect your receiver to the internet (when a DHCP server is present this will be easiest)
  6. Internet Connection will be checked
  7. Tuners will be setup, so you'll have to know which satellites you can connect to.
  8. When you have an Internet connection it will ask if you want to download a channel list.
  9. Then you will be asked if you want to download any plugins (like a Softcam).


Remember that if no Softcam is installed your card will not work and that if no channel list is installed, you will have to do a scan or download one from the settings section in the Plugin browser. Ofcourse you can change all the above settings afterwards, if you want.


Notice to HDMI-CEC users: By default the HDMI-CEC option is turned off. If you want to use the HDMI-CEC function...

  1. Go to Menu->Setup->System->Customize
  2. Put the Setup mode to Advanced and press green (OK)
  3. Select Audio / Video->HDMI-CEC setup and Enable the function.


AutoBackup


When you have made a backup with the plugin AutoBackup and this backup is on a media that is accessible from the startup of your receiver, than during the installation, OpenPli will restore all your settings, picons and some plugins. Well, the ones that are in the OpenPLi feed. Depending on your internet speed and the amount of data that has to be restored, this can take a few minutes.