Difference between revisions of "Receivers:Xtrend"
From OpenPLi Wiki
Rick Hunter (talk | contribs) |
Rick Hunter (talk | contribs) |
||
| Line 32: | Line 32: | ||
<u>Note:</u> In order to load the image automagically, rename the file called "noforce" to "force" | <u>Note:</u> In order to load the image automagically, rename the file called "noforce" to "force" | ||
| + | |||
| + | <u>'''Note:'''</u> When using a rotor unit on a ET8500 receiver, do not put the rotor on tuner 3 or 4. Somehow the rotor command's are not transmitted correctly so moving the dish isn't working. So put the rotor on tuner 1 or 2. | ||
Revision as of 19:35, 22 July 2017
Supported receivers
- ET4x00
- ET5x00
- ET6000
- ET6500
- ET7000
- ET7500
- ET8000
- ET8500
- ET9000
- ET9200
- ET9500
- ET10000
Broken Securityboard? Here is a repair instruction. (Not confirmed yet and in the German Language)
How to flash the receiver...
Download a image from: https://openpli.org Unpack the ZIP file and place the content on a USB disk.
FLASHING THE RECEIVER.
- Unzip compressed file.
- Copy the "etxxxx" folder to a USB Pen Drive.
- Power off or reboot the receiver with the mains switch on the rear. Connect USB Pen Drive.
- Power on receiver with the mains switch on the rear.
- After rebooting or cold start the power LED will blink several times after some time. At that moment press the power button on the front panel.
- Flashing of the image will start
- Booting will start automatically once the flashing process has completed
Note: In order to load the image automagically, rename the file called "noforce" to "force"
Note: When using a rotor unit on a ET8500 receiver, do not put the rotor on tuner 3 or 4. Somehow the rotor command's are not transmitted correctly so moving the dish isn't working. So put the rotor on tuner 1 or 2.
