Difference between revisions of "Receivers:Maxdigital"
From OpenPLi Wiki
m |
|||
| Line 11: | Line 11: | ||
# Wait for both the RED Recording LED and the LED on the front standby button to appear RED, once you see this you must press the CH+ located behind the flap on the front of the receiver to initiate the flashing process. <br /> | # Wait for both the RED Recording LED and the LED on the front standby button to appear RED, once you see this you must press the CH+ located behind the flap on the front of the receiver to initiate the flashing process. <br /> | ||
# Wait for the image to flash, during this time the Standby button LED will appear purple to indicate that the image is being flashed. <br /> | # Wait for the image to flash, during this time the Standby button LED will appear purple to indicate that the image is being flashed. <br /> | ||
| − | # When the flashing process has completed the receiver will automatically reboot. <br /> | + | # When the flashing process has completed the receiver will automatically reboot. <br /><br /> |
| + | Note: In order to load the image automagically, rename the file called "noforce" to "force" | ||
| + | |||
| + | After having flashed the box and the box starts to boot you continue with configuring the box. | ||
Revision as of 10:50, 8 May 2017
Supported receivers.
The only receiver that is or has been supported thus far is the Maxdigital XP1000.
Howto flash the box.
- Download an image on http://Openpli.org/download/maxdigital/ and unpack the image on a FAT32 formatted USBstick.
- Shut down the power of the receiver by switching off the powerswitch at the back of the receiver.
- Insert the USB stick containing the image files into the rear USB port on the receiver.
- Power on the receiver with the powerswitch as pushed before at the back of the box.
- Wait for both the RED Recording LED and the LED on the front standby button to appear RED, once you see this you must press the CH+ located behind the flap on the front of the receiver to initiate the flashing process.
- Wait for the image to flash, during this time the Standby button LED will appear purple to indicate that the image is being flashed.
- When the flashing process has completed the receiver will automatically reboot.
Note: In order to load the image automagically, rename the file called "noforce" to "force"
After having flashed the box and the box starts to boot you continue with configuring the box.
