Receivers:Xtrend

Supported receivers

• ET4x00
  
• ET5x00
  
• ET6000
  
• ET6500
  
• ET7000
  
• ET7500
  
• ET8000
  
• ET8500
  
• ET9000
  
• ET9200
  
• ET9500
  
• ET10000
  

Broken Securityboard? Here is a repair instruction. (Not confirmed yet and in the German Language) or try the new drivers look at take a look in the forum Looking for our Forum

How to flash the receiver...

Download a image from: https://openpli.org Unpack the ZIP file and place the content on a USB disk.

FLASHING THE RECEIVER.

1. Unzip compressed file.
   
2. Copy the "etxxxx" folder to a USB Pen Drive.
   
3. Power off or reboot the receiver with the mains switch on the rear. Connect USB Pen Drive.
   
4. Power on receiver with the mains switch on the rear.
   
5. After rebooting or cold start the power LED will blink several times after some time. At that moment press the power button on the front panel.
   
6. Flashing of the image will start
   
7. Booting will start automatically once the flashing process has completed
   

Note: In order to load the image automagically, rename the file called "noforce" to "force"

Note: When using a rotor unit on a ET8500 receiver, do not put the rotor on tuner 3 or 4. Somehow the rotor command's are not transmitted correctly so moving the dish isn't working. So put the rotor on tuner 1 or 2.